Hard Water Foaming Cleaner with Glass Protector

Glass partitions look dull and permanently dirty because hard water mineral deposits build up layer by layer standard glass cleaners cannot dissolve them.

This kit uses Hard Water Foam Cleaner to chemically dissolve the mineral bonds without scratching the glass, restoring full clarity.

Glass and Tile Stain Repellent is then applied to the clean surface forming a superhydrophobic invisible coating that makes water bead and roll off rather than sit and deposit minerals.

Clean once, protected for 6 months.

Step 1 - Spray Hard Water Foam Cleaner evenly across the glass partition working top to bottom. Leave for minimum 60 seconds up to 3 minutes for heavy build-up.

Step 2 - Scrub with a non-abrasive pad using horizontal strokes. Rinse thoroughly with clean water. Dry with a microfiber cloth. Repeat on any remaining hazy sections old staining may need 3 to 5 rounds.

Step 3 - Allow the glass to dry fully minimum 30 to 60 minutes. Surface must be completely dry before applying protector.

Step 4 - Apply Glass and Tile Stain Repellent onto the applicator pad and spread evenly in sections. Buff each section immediately with a clean dry microfiber cloth until completely transparent.

Step 5 - Leave undisturbed for 12 hours before water contact. Full protection active after 24 hours.

• Do not use Hard Water Foam Cleaner on any natural stone surrounds or frames it will etch and permanently damage marble or granite. Mask off stone edges before applying.
• Work in sections on large partitions do not try to treat the full panel at once.
• Glass must be completely dry with no moisture in edges or corners before applying the protector any moisture causes adhesion failure.
• Patch test Stain Repellent on frosted or etched glass before full application.
• Wear gloves for extended use of Hard Water Foam Cleaner on large surfaces. Avoid eye contact throughout.