Glass Foam Cleaner | 500ml x2

The most common problem with standard glass cleaners is streaking. Liquid sprays run down vertical glass surfaces before they can fully lift the grime, and as they dry they leave behind the very film they were meant to remove.

Dry wiping with a cloth does the same, it moves dust and oil around rather than removing it. Invisel Glass Foam Cleaner solves both problems with foam.

The foam clings to the glass surface and stays in place, giving the formula time to loosen fingerprints, dust film, soap scum, toothpaste splash, and water spots. When wiped away with a single clean microfiber cloth pass, the foam lifts everything off the glass completely, leaving a crystal-clear, streak-free surface.

Works on all glass and smooth hard surfaces which are bathroom mirrors, windows, glass shower partitions, glass doors and room dividers, glass furniture tops, TV screens, and display cases. One spray, one wipe, zero streaks.

Step 1 - Shake the bottle well
Shake before each use to ensure the formula is fully mixed for consistent foam output.

Step 2 - Spray foam evenly onto the glass surface
Hold the bottle 10 to 15 cm from the glass. Spray the foam in an even layer across the area you want to clean. The foam will cling to the glass surface without running or dripping.

Step 3 - Wait 20 to 30 seconds
Leave the foam undisturbed for 20 to 30 seconds. During this time the formula is loosening fingerprints, dust, soap marks, and water spots from the glass surface.

Step 4 - Wipe with a clean, dry microfiber cloth
Use a clean, dry microfiber cloth. Wipe in a single direction, top to bottom or side to side, in one smooth pass. Do not use a circular motion as this can redistribute the grime and cause streaking.

Step 5 - Buff with a second cloth if needed
For large surfaces like full-length mirrors or window panes, buff with a second clean dry cloth immediately after the first wipe for a perfectly clear, streak-free finish.

• Always use a clean microfiber cloth - a dirty, used, or low-quality cloth will leave streaks regardless of the product. If streaks appear, the cloth is the most likely cause.
• Do not use anti-reflective coated screens, anti-glare laptop screens, or prescription glasses, the formula is designed for architectural glass and mirrors, not optical coatings.
• For heavy hard water staining or thick limescale on glass, the Glass Foam Cleaner will clean the surface but may not fully dissolve thick mineral deposits. Use Invisel Hard Water Stain Remover for stubborn limescale, then follow up with Glass Foam Cleaner for a streak-free finish.
• Avoid spraying near open flames or in extremely hot environments.
• Keep out of reach of children during application. Once the glass is wiped dry the surface is completely safe.