Bathroom Protection Kit with Foaming Cleaner

Hard water stains keep coming back because the surface is unprotected. Every time water touches bare glass or unsealed stone and evaporates, it leaves another layer of mineral deposit behind.

Cleaning the stain without protecting the surface means you will be cleaning the same stain again within weeks. This three-product system fixes both the problem and the cause.

The Hard Water Foam Cleaner removes the existing limescale and hard water build-up from your glass shower panels, tiles, and fittings.

Once the surfaces are clean and fully dry, Glass Protector is applied to all glass surfaces forming an invisible nano-coating that makes water bead off the glass rather than sitting and evaporating on it.

Marble Protector is applied separately to all marble, granite, and stone surfaces sealing the porous stone so water, oil, and mineral deposits cannot penetrate.

The result is a bathroom that looks newly renovated, protects itself from hard water damage, and is dramatically easier to clean for the next 6 to 12 months.

This is the complete bathroom surface restoration system.

Step 1 - Clean all surfaces with Hard Water Foam Cleaner

Begin with completely dry surfaces. Shake the Hard Water Foam Cleaner. Spray foam onto all hard water stained areas glass panels, tiles, fittings, basins, and stone surfaces where visible staining exists. Leave for 1 to 3 minutes depending on stain age. Scrub with a brush or non-abrasive pad. Rinse thoroughly with clean water and dry completely with a clean cloth.

Step 2 - Check for remaining stains and repeat if needed

For old or heavily built-up stains, repeat the foam cleaner application once or twice more until the surface is clean. Do not apply either protector until the surface is fully stain-free and completely dry.

Step 3 - Apply Glass Protector to glass and ceramic surfaces

Once all glass, ceramic tile, and fitting surfaces are fully dry, apply Glass Protector. Shake well. Apply a small amount onto the applicator pad included and spread evenly across the glass or tile surface using smooth, overlapping strokes. Buff until the surface is completely transparent with no smearing. Allow to cure for 12 hours before water exposure.

Step 4 - Apply Marble Protector to stone surfaces separately

Apply Marble Protector to all marble, granite, and stone surfaces as a separate application after the Glass Protector is complete. Shake well. Hold 8 to 10 cm from the surface and spray evenly. Spread with an applicator pad and buff until transparent. Allow to cure for 12 hours before water exposure. Do not apply Marble Protector to glass or do not apply Glass Protector to stone.

• Do not apply Glass Protector or Marble Protector to wet or damp surfaces surfaces must be fully dry and stain-free before either protector is applied.
• Hard Water Foam Cleaner must not be used on natural marble or granite use it only on glass, ceramic tiles, and chrome fittings. The foam cleaner's acid activity can etch natural stone.
• Apply Glass Protector and Marble Protector in separate applications they are formulated for different surface chemistries and should not be mixed or applied to each other's surfaces.
• Both protectors require a 12-hour curing period before water contact. Do not use the bathroom for at least 12 hours after applying either protector.
• Keep all products out of reach of children during application. All surfaces are safe once cured and dry.