How to use_marble & granite stain repellent

Marble & Granite Stain Repellent

Nano-seals stone pores so turmeric, oil and food stains cannot penetrate — for up to 6 months.

MarbleGraniteKitchen CountersBathroom Stone

6 months

Protection

20 min

Application

12 hrs

Cure time

0:00 / 0:00

How To Apply Marble & Granite Stain Repellent

Remove all existing stains and deposits first

The Marble Protector bonds only to a clean, stain-free and dry surface. If existing turmeric, oil, mineral deposits or grime are present, remove them first. Use Invisel Hard Water Stain Remover for mineral deposits — spray, wait 3–5 minutes, wipe off. Use Invisel Kitchen Stain Remover for oil and food residue. Rinse thoroughly and dry completely before applying the protector.

💡 Coating on a stained or damp surface is wasted coating. The nano particles need to bond directly to the stone.

Ensure the stone is completely dry

After cleaning, wipe with a dry microfibre cloth and allow to air dry. The stone must be completely dry — even slight moisture will prevent the nano coating from bonding correctly and reduce protection duration significantly.

⏰ For bathroom stone, wait at least 2 hours after cleaning before applying. For kitchen counters wiped with a damp cloth, wait 30–60 minutes.

Shake the bottle well

Shake the bottle vigorously for 15 seconds before spraying. This ensures the nano particles are evenly distributed in the solution for consistent coverage across the stone.

⚠️ Do not apply in direct sunlight or on warm surfaces. Do not apply on a hot kitchen counter — allow to cool completely.

Spray and spread section by section

Work in manageable sections of 1m × 1m. Hold the bottle 8–10cm from the stone and spray a small, even amount. Immediately spread with the applicator pad in circular or sweeping motions, covering the section evenly. Do not spray the entire surface at once — the product will begin to dry before you can spread it properly.

✨ For highly porous stone like Kota stone or unpolished granite, a second coat applied 30 minutes after the first significantly improves coverage and duration.

Buff

Using a clean dry microfibre cloth, buff the surface in circular motions until smooth, non-sticky and uniform. Remove all excess product — do not leave thick patches or pooling as this causes uneven curing and a hazy finish.

💎 The surface will look slightly richer and deeper in colour after buffing — the nano coating enhances the stone's natural colour without adding film or sheen.

Cure for 12 hours — no water or food contact

Keep all treated surfaces dry and free from water, food and foot traffic for at least 12 hours. Full curing and maximum protection achieved in 24 hours. After 24 hours, test with a few drops of oil or water — they should bead clearly on the surface without spreading.

🌙 Apply in the evening so kitchen counters cure overnight and are ready for cooking the next morning.